LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2023 >> ID.4 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Passenger Protection, Airbags, Seat Belts) >> 69 Passenger Protection, Airbags, Seat Belts >> Pedestrian Protection >> Overview - Pedestrian Protection

Overview - Pedestrian Protection

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.
GWWN69-10917Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Clip
  2. Pedestrian Protection Trigger 1 -G598-
  3. Pedestrian Protection Center Crash Sensor -G693-
  4. Bolt
    • 6 Nm
  5. Pressure Hose Sensor for Front Pedestrian Protection -G579-
    • Component location: in molded foam part on impact member
    • Must be replaced when
      • Molded foam part visibly damaged
      • The impact member is visibly deformed.
      • The bumper cover is deformed.
      • The pressure hose is damaged.
    • Place the pressure hose in the groove on the molded foam part.
    • Insert the pressure hose in the molded foam part, excess pieces are routed without kinks in the balancing zones
    • Do not kink or squeeze the pressure hose.
    • Removing and Installing. Refer to Pressure Hose Sensor for Front Pedestrian Protection -G579-, REMOVING AND INSTALLING .
  6. Driver Side Pedestrian Protection Crash Sensor 2 -G851-
    • Component of Pressure Hose Sensor for Front Pedestrian Protection -G579-
  7. Bolt
    • 6 Nm
  8. Driver Side Pedestrian Protection Crash Sensor -G570-
  9. Bolt
    • 6 Nm
  10. Front Passenger Side Pedestrian Protection Crash Sensor -G571-
  11. Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
    • Component of Pressure Hose Sensor for Front Pedestrian Protection -G579-
  12. Pressure Hose Sensor for Front Pedestrian Protection -G579-
    • Component location: in molded foam part on impact member
    • Must be replaced when
      • Molded foam part visibly damaged
      • The impact member is visibly deformed.
      • The bumper cover is deformed.
      • The pressure hose is damaged.
    • Place the pressure hose in the groove on the molded foam part.
    • Insert the pressure hose in the molded foam part, excess pieces are routed without kinks in the balancing zones
    • Do not kink or squeeze the pressure hose.
    • Removing and Installing. Refer to Pressure Hose Sensor for Front Pedestrian Protection -G579-, REMOVING AND INSTALLING .
  13. Pedestrian Protection Trigger 2 -G599-
  14. Clip
scientia non olet · About LEMON Manuals