Seals at the connection locations of lines to the various components
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
A - Loss Protection Device
- Replacing. Refer to Seals of the adjusting bolts of the pressure and temperature sensors .
- Remove by hand
- Install without oil
- Note the different versions. Refer to Parts Information.
B - Seal
- Replacing. Refer to Seals of the adjusting bolts of the pressure and temperature sensors .
- Remove by hand
- Install without oil
- Before installing, check the sealing surfaces on the components for contamination or damage.
- No specific installation position required.
- Note the different versions. Refer to Parts Information.
- The seal seals the refrigerant circuit. Seals made out of metal (with a special coating) are currently used for refrigerant R744. These metal rings seal off the connection points between components that are bolted/screwed on and the refrigerant circuit.