Overview - Assembly Mounts
WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Replace
- Tightening specification and sequence. Refer to Fig 2.
- Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
- Engine Mount
- With support arm
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Bolt
- Replace
- 40 Nm +90°
- Bolt
- Replace
- 20 Nm +90°
- Bolt
- Replace
- 40 Nm +90°
- Bolt
- Replace
- 60 Nm +90°
- Pendulum Support
- Removing and Installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Replace
- Tightening specification and sequence. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Replace
- Tightening specification and sequence. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Replace
- Tightening specification and sequence. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Replace
- 60 Nm +90°
- Bolt
- Replace
- 60 Nm +90°
- Transmission Mount
- With support arm
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Bolt
- Replace
- 50 Nm + 90°