Sub-Assembly Bracket, Removing And Installing: Installing
WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.
-- Bring the sub-assembly bracket -3- into the installation position and tighten the After-Run Coolant Pump -- -1- -arrows-.
-- Place the sub-assembly bracket -3- on the engine and tighten the fitting bolt -1- first by hand.
-- Then tighten the bolts -2- by hand.
-- Tighten all bolts diagonally to the tightening specification.
- Tightening specification Refer to OVERVIEW - CYLINDER BLOCK, BELT PULLEY SIDE .