Overview - Bevel Box
WARNING: This page is about a different variant/trim than selected.
- Bolt
- Tightening Specification. Refer to OVERVIEW - DIFFERENTIAL, AWD AND FWD WITH FRONT AXLE DIFFERENTIAL LOCK .
- Heat Shield
- Nut
- Quantity: 2 or 3
- Tightening specification. Refer to OVERVIEW - DRIVE AXLE .
- Bolt
- For heat shield on bevel box
- Tightening specification. Refer to the appropriate Service Information .
- Heat Shield
- For driveshaft
- Bolt
- For heat shield on bevel box
- Tightening specification. Refer to the appropriate Service Information .
- Bevel Box
- Removing. Refer to BEVEL BOX, REMOVING .
- Installing. Refer to BEVEL BOX, INSTALLING .
- Bolt
- Quantity: 4
- Replace after removing
- Tightening Specification. Refer to OVERVIEW - DIFFERENTIAL, AWD AND FWD WITH FRONT AXLE DIFFERENTIAL LOCK .
- Transmission Support
- There are different versions. Refer to the Parts Information for the allocation.
- Bolt
- Quantity: 2
- Transmission support to bevel box
- Tightening specification and sequence. Refer to Fig 2.
- Bolt
- Quantity: 2
- Transmission support to engine
- Tightening specification and sequence. Refer to Fig 2.
Tightening Specification and Sequence for Bevel Box Transmission Support
Bolt allocation
| Item | Bolt | Quantity |
|---|---|---|
| 1 | M10 x 55 | 2 |
| 2 | M10 x 20 | 2 |
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1 | All | Install all the way by hand |
| 2 | -1- | 40 Nm |
| 3 | -2- | 40 Nm |