Engine, Securing To Engine And Transmission Holder

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Special Tools - Engine, Securing To Assembly Stand

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Special tools and workshop equipment required

Engine Sling:2024 A
Shop Crane:VAS 6100
Engine and Transmission Holder:VAS 6095 or Engine and Transmission Holder:VAS 6095A

Procedure

The transmission is separated from the engine. Refer to ENGINE AND TRANSMISSION, SEPARATING .

-- Unlock the retaining tab -arrow- and remove the left engine cover mount -1-.

Fig 2: Identifying Engine Cover Mount

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip the right engine cover mount -1-.

Fig 3: Identifying Engine Cover Mount And Locating Bore

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Engage the Engine Sling:2024 A onto the engine and onto the Shop Crane:VAS 6100 .

Fig 4: Engine Lifted

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- To be aligned to the center of gravity of the engine assembly, the hole rails must be inserted as shown.

-- Secure the mounting hooks and pins on the engine support bridge using securing pins -arrows-.

-- Lower the engine from the Engine and Gearbox Jack:VAS 6931 using the Shop Crane:VAS 6100 .

-- Remove the transmission alignment sleeves and fasten the transmission side of the engine on the Engine and Transmission Holder:VAS 6095A .

Fig 5: Identifying Engine And Transmission Holder

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.