Sensor Wheel, Pressing On

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure the : T10134  on the crankshaft flange -1-.

-- Pay attention that the : T10134  locating pin is seated in the sensor wheel hole.

-- Tighten the hex socket bolts -E- hand-tight.

-- Push the : T10134  by hand to the sealing flange -1-.

-- Install the nut -B- as far as possible on the threaded spindle by hand until it touches the : T10134  .

-- Insert the gasoline engine guide pins (red handle) -F- in the crankshaft flange.

-- Push the knurled bolts -H- in the sealing flange -1-.

-- Install two M6 x 35 bolts -2- into the cylinder block to guide the sealing flange.

-- Tighten the nut -B- for the : T10134  to 40 Nm.

Fig 1: Identifying Seal Installer - Rear Crankshaft Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Check the sensor wheel installation position on the crankshaft one more time. Refer to Sensor Wheel Installation Position on Crankshaft, Checking .

-- Tighten the nut on the : T10134  to 45 Nm if the specified value is too small.

-- Check the sensor wheel installation position on the crankshaft one more time. Refer to Sensor Wheel Installation Position on Crankshaft, Checking .