Sealing Flange, Removing And Installing, Transmission Side: Assembling
-- Tighten the sealing flange bolts diagonally.
-- Install the oil pan lower section. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
-- Install the intermediate plate. Refer to Figure.
-- Install the flywheel. Refer to FLYWHEEL, REMOVING AND INSTALLING .
-- Connect a Vehicle Diagnostic Tester.
-- After replacing the sensor wheel an adaptation of the combustion misfire must be performed. To do so select the function 01 - Reset combustion misfire adaptation in Guided Functions .
Tightening Specifications
- Refer to Figure
- Refer to Fig 1
- Refer to OVERVIEW - CYLINDER BLOCK, TRANSMISSION SIDE
- Engine Speed Sensor -G28-. Refer to OVERVIEW - IGNITION SYSTEM .