LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Golf Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Cylinder Head, VALVETRAIN (4-Cylinder Direct Injection (1.8L; 2.0L, 4V, Turbocharger, Chain Drive, Ea888, Generation III))) >> 15 Cylinder Head, VALVETRAIN >> Timing Chain Cover >> Timing Chain Cover, Removing And Installing >> Upper Timing Chain Cover, Removing And Installing >> Installing

Upper Timing Chain Cover, Removing And Installing: Installing

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
GWWA15-11235Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Replace seals.

-- Install the cover on the cylinder head the tighten the bolts hand tight. While doing so make sure that the seal lays correctly on the cylinder head.

-- Tighten the bolts -1 through 6- in the sequence shown. Refer to Figure.

-- Install the Camshaft Adjustment Valve 1 -N205- and Exhaust Camshaft Adjustment Valve 1 -N318-. Refer to Camshaft Adjustment Valve 1 -N205- AND Exhaust Camshaft Adjustment Valve 1 -N318-, REMOVING AND INSTALLING .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

Tightening Specifications 

scientia non olet · About LEMON Manuals