Overview - Camshaft Housing
WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Cylinder Head
- O-Ring
- Coat with engine oil
- If damaged replace together with the cam adjustment actuator
- Only installed on vehicles with the engine codes CHHB, CNTA, CXCA, CXDA, CXCB, CXDB and DKFA
- Cam Adjustment Actuator
- Only installed on vehicles with the engine codes CHHB, CNTA, CXCA, CXDA, CXCB, CXDB and DKFA
- Bolt
- 5 Nm
- Only installed on vehicles with the engine codes CHHB, CNTA, CXCA, CXDA, CXCB, CXDB and DKFA
- Ball Pin
- 9 Nm
- For engine cover
- O-Ring
- Replace if damaged
- Coat with engine oil
- Plug
- O-Ring
- Replace after removing
- Coat with engine oil
- Camshaft Position Sensor 3 -G300-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- Tightening specification. Refer to OVERVIEW - IGNITION SYSTEM .
- Oil Separator
- Removing and installing. Refer to OIL SEPARATOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Fig 3.
- Seal
- Replace after removing
- Vacuum Pump
- Removing and installing. Refer to VACUUM PUMP, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to Fig 2.
- Seal
- Replace after removing
- O-Ring
- Replace after removing
- Coat with engine oil
- Camshaft Position Sensor -G40-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- Tightening specification. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- 9 Nm
- Bracket
- For EVAP Canister Purge Regulator Valve 1 -N80-
Vacuum Pump - Tightening Specifications
Tighten with a new bolts as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 3- | Install hand-tight |
| 2. | -1 through 3- | 8 Nm |
| 3. | -1 through 3- | 180° additional turn |