Overview - Ignition System
WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 8 Nm + 90°
- Replace after removing
- The tightening specification affect how the knock sensor functions
- Knock Sensor 1 -G61-
- Removing and installing. Refer to Knock Sensor 1 -G61-, REMOVING AND INSTALLING .
- Spark Plug
- 30 Nm
- Remove and install using Spark Plug Removal Tool:3122B
- Ignition Coil with Power Output Stage
- 10 Nm
- Ignition Coil 1 with Power Output Stage -N70-
- Ignition Coil 2 with Power Output Stage -N127-
- Ignition Coil 3 with Power Output Stage -N291-
- Ignition Coil 4 with Power Output Stage -N292-
- Ignition coils with power output stage and spark plug connectors can be obtained individually for repairs
- Removing and installing. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- On vehicles with the engine codes CHHB, CNTA, CXCA, CXDA, CXCB, CXDB and DKFA
- Camshaft Position Sensor 3 -G300-
- On vehicles with the engine codes CHHB, CNTA, CXCA, CXDA, CXCB, CXDB and DKFA
- Removing and installing. Refer to Camshaft Position Sensor 3 -G300-, REMOVING AND INSTALLING .
- O-Ring
- Replace if damaged
- On vehicles with the engine codes CHHB, CNTA, CXCA, CXDA, CXCB, CXDB and DKFA
- O-Ring
- Replace if damaged
- Camshaft Position Sensor -G40-
- Removing and installing. Refer to Camshaft Position Sensor -G40-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-Ring
- Replace if damaged
- Engine Speed Sensor -G28-
- Check the O-ring for damage
- Removing and installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm