Charge Air Pressure Actuator -V465-, REMOVING AND INSTALLING: Installing

• If the charge air pressure actuator is replaced, apply the installation position of the lock nut on the new charge air pressure actuator.

-- Bring the Charge Air Pressure Actuator -V465- into the installation position and tighten the bolts -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the control rod until it contacts the lock nut -2- in the operating lever -1-.

-- Connect the connector -4-.

-- Adjust the charge air pressure actuator. Refer to Charge Air Pressure Actuator -V465-, ADJUSTING .

-- After replacing the Charge Air Pressure Actuator -V465- the adaptation values must be adjusted.