Overview - EVAP System, EVAP Canister In Engine Compartment
WARNING: This page is about a different variant/trim than selected.
NOTE:
Hose connections are secured with either spring or hose clamps.
Replace the locking clamps with spring clamps.
: VAS6340 and the : VAS6362 are recommended for installing spring-type clips.
The connector couplings must >>audibly<< engage when locking.
Note the color coding when installing the connector coupling. Refer to Connector Coupling Allocation !
Pull on the connector coupling to check for secure fit.
Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS .
- EVAP Canister
- Component location: in the engine compartment on the right side
- Removing and Installing. Refer to EVAP CANISTER, REMOVING AND INSTALLING, EVAP CANISTER IN ENGINE COMPARTMENT .
- Bracket
- For the EVAP canister
- Nut
- 10 Nm
- Engine Mount
- Bolts
- 10 Nm
- Connecting Line
- With the pressure regulator valve in the connecting line
- Check for secure fit
- From the fuel tank
- Connecting Line
- To Intake Manifold
- Check for secure fit
- EVAP Canister Purge Regulator Valve 1 -N80-
- The valve is closed when the ignition is off
- Valve is activated (pulsed) by the engine control module when the engine is warm
- Vent Hole