Wiring Harness For Sensors, Removing And Installing: Procedure

WARNING: This page is about a different variant/trim than selected.

-- Drain the ATF. Refer to ATF, DRAINING AND FILLING .

-- Remove the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .

-- Remove the transmission fluid screen. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .

-- Remove the valve body. Refer to VALVE BODY, REMOVING AND INSTALLING .

-- Disconnect the sensor connector -1- from the transmission connector.

Fig 1: Identifying 8-Pin (G68) & 14-Pin (G93) Electrical Harness Connectors

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the 8-pin transmission connector bolt.

-- Remove the connector and the wiring harness outward from the transmission housing.

Install in the reverse order of removal while noting the following:

-- Replace the O-ring on the connector.

-- Coat the O-ring with ATF.

-- Push the connector with the new O-ring all the way into the transmission.

-- Tighten the bolt for the 8-pin transmission connector. Refer to Tightening Specifications .

-- Install the valve body. Refer to VALVE BODY, REMOVING AND INSTALLING .

-- Install the transmission fluid screen. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .

-- Install the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .

-- Fill the ATF, and check the ATF level and add ATF if necessary. Refer to ATF .

Tightening Specifications