Wire Routing, Connectors And Bracket On Valve Body

WARNING: This page is about a different variant/trim than selected.

Installation Position: Solenoid Valves; Wire Routing and Connectors

NOTE:

Information regarding assembly work on the valve body is shown in illustrations in this chapter.

Before the connectors are disconnected from the sensors and solenoid valves, the solenoid valves or the sensors and their associated connectors must be marked.

Fig 1: Identifying Wire Routing, Connectors And Bracket On Valve Body

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Solenoid Valve 4 -N91-
Solenoid Valve 6 -N93-
Solenoid Valve 5 -N92-
Solenoid Valve 9 -N282-
Solenoid Valve 10 -N283-
Solenoid Valve 3 -N90-
Solenoid Valve 1 -N88-
Solenoid Valve 2 -N89-
A - Connector for Transmission Output Speed Sensor -G195-
B - Connector for Transmission Input Speed Sensor -G182-

Connector Bracket, Securing Wiring

NOTE:

The -arrows- point to the locations where the wires are fastened to the valve body.

Fig 2: Identifying Bracket For Connectors, Securing Wires

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Connector Bracket for Transmission Output Speed Sensor -G195-
- Tightening Specification. Refer to Tightening Specifications .
Connector Bracket for Transmission Input Speed Sensor -G182-
- Tightening Specification. Refer to Tightening Specifications .
Transmission Fluid Temperature Sensor -G93-
Selector Lever
- Tightening Specification. Refer to Tightening Specifications .
Arrow -
- The wires are attached >>here<<