Tightening Specifications

WARNING: This page is about a different variant/trim than selected.

Refer to OVERVIEW - LOWER CONTROL ARM AND BALL JOINT
Refer to OVERVIEW - SUBFRAME
Refer to OVERVIEW - SUBFRAME BRACE
Refer to OVERVIEW - STEERING GEAR
Pendulum support bolts. Refer to ASSEMBLY MOUNT .
Underbody trim panel bolts. Refer to OVERVIEW - UNDERBODY TRIM PANELS .
Noise insulation bolts. Refer to OVERVIEW - UNDERBODY TRIM PANELS .
Clamping sleeve tightening specification. Refer to CLAMPING SLEEVE INSTALLATION POSITION .

-- After installing , perform the basic setting on the Steering Angle Sensor -G85-. Refer to Vehicle Diagnostic Tester.