Battery Test With Vehicle Diagnostic Tester
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
The Battery -A- can also be checked. Refer to Vehicle Diagnostic Tester when it is installed and without being connected to a battery charger.
Test Requirements
- No battery charger connected.
- Battery -A- is connected.
- Battery temperature at least +10 °C (50 °F).
Procedure
-- Connect the Vehicle Diagnostic Tester. Refer to CONNECT THE Vehicle Diagnostic Tester .
-- Select the Diagnostic mode and start the diagnosis.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Body
- Electrical system
- 27 - Starter, Voltage supply
- Electrical Components
- A - Battery, Checking
The Vehicle Diagnostic Tester continues with the battery test from here on.