CONNECT THE Vehicle Diagnostic Tester

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Vehicle Diagnostic Tester

NOTE:

Follow the current operating instructions for the Vehicle Diagnostic Tester, which can be displayed after selecting "Administration" and "operator's handbook" buttons.

Procedure

-- Turn off the ignition and all electrical equipment and remove the ignition key.

-- On vehicles with automatic transmissions, move the selector lever to the "P" or "N" position.

-- On vehicles with manual transmissions, move the shift lever to the neutral position.

-- When the ignition is switched off, connect the Vehicle Diagnostic Tester to the vehicle data link connector -arrow-.

Fig 1: Locating Data Link Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Switch the ignition on.

The method for connecting all. Refer to Vehicle Diagnostic Tester can be derived from the sequence described above.

Component location and connector assignment for the data link connector. Refer to the appropriate Wiring Diagram.