LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Exterior Lights, Switches (Convertible)) >> 94 Exterior Lights, Switches >> Description And Operation >> Access/Start Authorization System Overview

Access/Start Authorization System Overview

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

DTC Recognition And Display

The access/start authorization system has OBD.

Use the Vehicle Diagnostic Tester in "Guided Fault Finding".

General Information

The access/start authorization regulates keyless opening, locking and starting of the vehicle.

Opening

The ID sensor in ignition key must be located within reception range of lock location of approximately 1.5 meters (5 ft.). The proximity sensor located on the inside of the door handle is activated whenever the handle is touched. This then speaks to the ID sensor inside the key and the door unlocks immediately if the identification is valid. Pulling the exterior door handle opens the vehicle.

Starting

The ID sensor in ignition key must be located in the vehicle interior. The clutch pedal must pressed on manual transmission vehicles. On vehicles with an automatic transmission and DSG, the selector lever must be in "P" and the brake pedal must be pressed. Press the Start System Button -E378- briefly. This speaks to the ID sensor in the key and if the identification is valid, the steering wheel unlocks and the vehicle can be started.

It is only possible to start the engine with the Start System Button -E378- when a valid ID sensor (inside the key) is located in the vehicle interior.

Locking

The ID sensor in ignition key must be located within reception range of lock location of approximately 1.5 meters (5 ft.). Touching the locking sensor on the outside of the door handle activates the sensor. This then speaks to the ID sensor inside the key and the vehicle unlocks if the identification is valid.

The Access/Start Authorization Control Module -J518- controls all access/start functions, refer to ACCESS/START AUTHORIZATION COMPONENTS .

Fig 1: Identifying Access/Start Authorization System Components Overview
GWWM94-10149Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Antenna Contact Point Coverage Area
  2. Access/Start System Antenna 1 in Vehicle Interior -R138-
  3. Front Passenger Exterior Door Handle
  4. Access/Start System Antenna In Luggage Compartment -R137-
  5. Access/Start System Antenna In Rear Bumper -R136-
  6. Access/Start System Antenna 2 in Vehicle Interior -R139-
  7. Driver Side Outside Door Handle
  8. Access/Start Authorization Button -E378-
  9. Access/Start Authorization Control Module -J518-