Wiring Harness, Sensors

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

-- Drain the ATF. Refer to ATF, DRAINING AND FILLING .

-- Remove the ATF pan. Refer to OIL PAN .

-- Remove the ATF strainer. Refer to ATF STRAINER .

-- Remove the valve body. Refer to VALVE BODY .

-- Disconnect the sensor connector -1- from the transmission connector.

Fig 1: Identifying 8-Pin (G68) & 14-Pin (G93) Electrical Harness Connectors

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt from the 8-pin transmission connector.

-- Remove the connector and the wiring harness from the transmission housing.

Install in reverse order of removal. Note the following:

-- Replace the O-ring on the connector.

-- Coat the O-ring with ATF.

-- Push the connector with a new O-ring all the way into the transmission.

-- Tighten the bolt for the 8-pin transmission connector. For the correct tightening specification.

-- Install the valve body. Refer to VALVE BODY .

-- Install the ATF strainer. Refer to ATF STRAINER .

-- Install the ATF pan. Refer to OIL PAN .

-- Fill the ATF and check the level. Refer to ATF LEVEL, CHECKING .

Tightening Specifications

The bolt for the 8-pin transmission connector. Refer to VALVE BODY OVERVIEW .