Transmission Output Speed Sensor -G195-

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

-- Drain the ATF. Refer to ATF, DRAINING AND FILLING .

-- Remove the ATF pan. Refer to OIL PAN .

-- Remove the ATF strainer. Refer to ATF STRAINER .

-- Remove the valve body. Refer to VALVE BODY .

-- Remove the bolt -2- from the Transmission Output Speed Sensor -G195-.

Fig 1: Identifying Transmission Input G182 & Output G195 Speed (RPM) Sensors

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the tTransmission Output Speed Sensor from the transmission housing.

Install in reverse order of removal. Note the following:

-- Push the Transmission Output Speed Sensor all the way into the transmission housing.

-- Tighten the bolt -2- from the Transmission Output Speed Sensor -G195-.

-- Install the valve body. Refer to VALVE BODY .

-- Install the ATF strainer. Refer to ATF STRAINER .

-- Install the ATF pan. Refer to OIL PAN .

-- Fill the ATF and check the level. Refer to ATF LEVEL, CHECKING .

Tightening Specifications

Transmission Output Speed Sensor bolt. Refer to VALVE BODY OVERVIEW .