Data Bus On Board Diagnostic Interface -J533- Function

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

General Information

The Data Bus On Board Diagnostic Interface -J533- is designed as a separate control module. It has the following tasks in the vehicle:

Perform data exchange between CAN-Bus systems "Powertrain CAN-Bus", "Convenience CAN-Bus" and "Infotainment CAN-Bus".

If the Data Bus On Board Diagnostic Interface -J533- is to be replaced, refer to DATA BUS ON BOARD DIAGNOSTIC INTERFACE -J533-, ADAPTING FUNCTIONS . The procedure must be performed to read out (copy) the codes stored in the module.

DTC Recognition And Display

The Data Bus On Board Diagnostic Interface -J533- is equipped with OBD.

Use the Vehicle Diagnostic Tester in "Guided Fault Finding".

The Data Bus On Board Diagnostic Interface -J533- is installed in the right footwell on the driver side next to the steering column.

Before removing the Data Bus On Board Diagnostic Interface -J533-, refer to DATA BUS ON BOARD DIAGNOSTIC INTERFACE -J533-, ADAPTING FUNCTIONS . The procedure must be performed must be performed to read out (copy) the codes stored within it.