Windshield Wiper Motor -V-

General Information 

The Wiper Motor Control Module -J400- is integrated with the Windshield Wiper Motor -V-.

DTC Recognition And Display

The Vehicle Electrical System Control Module -J519- is equipped with OBD.

Use the Vehicle Diagnostic Tester in "Guided Fault Finding".

Removal 

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Remove the wiper frame together with the linkage rod, refer to WIPER FRAME WITH LINKAGE AND Windshield Wiper Motor -V- .

-- Pry off ball head -arrow- of linkage -1- from motor crank using Pry Lever 80-200.

Fig 1: Identifying Removing Windshield Wiper Motor Linkage With Pry Lever 80--200

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -1-.

Fig 2: Identifying Wiper Motor Crank, Bolts, And Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the motor crank -2- from the Windshield Wiper Motor shaft.

-- Remove the mounting bolts -arrows- and remove the Windshield Wiper Motor -V- with the Windshield Wiper Motor Control Module -J400- from the wiper frame.

Installation 

-- Install the Windshield Wiper Motor -V- with the Windshield Wiper Motor Control Module -J400- in the wiper frame and tighten the bolts -arrows-.

Fig 3: Identifying Wiper Frame Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mount the motor crank -4- onto the Windshield Wiper Motor -V- shaft -2- so that the three points -1-, -2- and -3- are in a line.

Fig 4: Identifying Motor Crank -4-, Wiper Motor Shaft -2- And Alignment Of Points -1 To 3-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the motor crank and the Windshield Wiper Motor -V- shaft with the nut -2-.

-- Push the ball head -arrow- on the linkage -1- onto the motor crank.

Fig 5: Installing Wiper Motor Linkage

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tightening Specifications 

• Refer to FASTENER TIGHTENING SPECIFICATIONS .