Transmission Fluid Cooler: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Replace the O-rings -C- on the transmission fluid cooler -B-.

Fig 1: Identifying Transmission Oil Cooler

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mount the transmission fluid cooler -B-, while doing this, pay attention to the O-rings -C-.

-- Install new bolts -A- and tighten to the tightening specification.

-- Attach the coolant hoses to the transmission fluid cooler and remove the Hose Clamps 3094.

Fig 2: Clamping Off Coolant Hoses Using Clamps 3094

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the battery and the battery tray. Refer to Removal and Installation .

-- Check the coolant level and add if necessary. Refer to FILLING .

Fig 3: Attention (Switch Off Engine)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- After repairing, check the transmission fluid level and fill. Refer to TRANSMISSION FLUID LEVEL, CHECKING .

CAUTION:

Do not start engine during coolant level test if the transmission fluid has not been filled yet.