LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Controls, Housing - Manual Transmission 02Q (Convertible)) >> 34 Controls, Housing >> Description And Operation >> Clutch Housing Overview

Clutch Housing Overview

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of Clutch Housing Components
GWWM34-10037Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Bearing Bushing
    • For the selector shafts.
    • Always replace if removed.
    • Removing, refer to Figure.
    • Installing, refer to Figure.
  2. Needle Sleeve
    • For the reverse gear shaft.
    • Always replace if removed.
    • Removing, refer to Figure.
    • Installing, refer to Figure.
  3. Alignment Sleeve
    • Quantity: 2
  4. Clutch Housing
  5. Cap
    • Not on all clutch housings.
  6. Input Shaft Seal
    • Removing, refer to Fig 2.
    • Installing, refer to Fig 3.
  7. Seal
  8. Washer
    • For the differential.
    • Installed position: The shoulder on the inner circumference faces the seal -item 7-.
  9. Outer Race/Tapered Roller Bearing
  10. Oil Deflector Ring
    • Installed position: The shoulder on the hole faces the output shaft.
  11. Outer Race/Tapered Roller Bearing
  12. Outer Race/Tapered Roller Bearing
  13. Washer
    • Output shaft, 5th, 6th and reverse gears.
    • Always 0.65 mm thick.
  14. Cylindrical Roller Bearing
  15. Magnet
    • Held in place by the housing joint surface.
Fig 2: Identifying Input Shaft Pried-Out Seal Using Extractor Lever T20143/1
GWWA34-0614Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Fig 3: Driving In Input Shaft Oil Seal Flush
GWWN34-1017Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
scientia non olet · About LEMON Manuals