Rear Axle Camber, Adjusting, Multi-Link Suspension

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Insert Tool 18T10179

-- Loosen nut -A- of threaded connection of upper transverse link at subframe.

Fig 1: Identifying Upper Transverse Link Threaded Fastener Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Adjust camber by turning hex of eccentric bolt -arrow-.

NOTE:

The maximum adjustment range is 90° to left or right of center position.

-- Tighten the nut -A-.

Fig 2: Identifying Upper Transverse Link Threaded Fastener Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Use the Insert Tool 18T10179 for this.

Fig 3: Identifying Nut And T10179

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Tighten the nut to 80 Nm using the Insert Tool 18T10179.

-- Check the camber value again after tightening the nut -A-.

Tightening Specifications

Refer to SUBFRAME OVERVIEW .