Dual Clutch, Installing: Notes

WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Clutch Retaining Bar:T10303

Requirement

To install the clutch, the transmission must be secured in a vertical position on the assembly stand. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .
The large lamella carrier is inserted in all clutch discs in the clutch. The large lamella carrier must not slipped out of the lowest clutch disc.
Adjust the clutch axial play when installing.
Transmission fluid pump shaft is removed.
Do not install any wavy circlips