Overview - Oil Pan/Oil Pump
WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If large quantities of metal shavings or other deposits such as those caused by partial seizure of the crankshaft or connecting rod damage are found in the engine oil, clean the oil channels thoroughly and replace the engine oil cooler to prevent further damage.
- Nut
- 9 Nm
- Oil Level Thermal Sensor -G266-
- Removing and installing. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- O-Ring
- Replace after removing
- Coat with engine oil
- Oil Drain Plug/Plug
- Sheet metal oil pan: 30 Nm
- Plastic oil pan: turn all the way using a flat-head screwdriver or a coin
- Seal/O-Ring
- Replace after removing
- Oil Pan Lower Section
- Removing and installing. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
- Seal
- Not installed
- Bolt
- 4 Nm +45°
- Replace after removing
- For the oil baffle and oil intake pipe
- Oil Baffle
- Replace after removing
- O-Ring
- Coat with engine oil
- Replace after removing
- Oil Intake Pipe
- Clean the screen if it is dirty.
- O-Ring
- Replace after removing
- Coat with engine oil
- Oil Pump
- Removing and installing. Refer to OIL PUMP, REMOVING AND INSTALLING .
- Centering Bracket
- Bolt
- Replace after removing
- Tightening sequence. Refer to Fig 2
- Oil Pan Upper Section
- Tightening sequence. Refer to Fig 3
- Removing and installing. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Cylinder Block
- Oil Pump Drive Chain
- Mark direction of rotation before removing
- Bolt
- 9 Nm
- Chain Tensioner
- O-Ring
- Replace after removing
- Coat with engine oil
- Oil Pressure Regulation Valve -N428-
- Removing and installing. Refer to Oil Pressure Regulation Valve -N428-, REMOVING AND INSTALLING .
- Bolt
- Tightening specification -Item ) OVERVIEW - OIL PRESSURE SWITCH/OIL PRESSURE REGULATION VALVE - List Item: Bolt.
- Oil Pump Bolt
- 8 Nm +90°
- Replace after removing
- Oil Pump Bolt
- 8 Nm +90°
- Replace after removing
- Oil Intake Pipe Bolt
- 4 Nm +45°
- Replace after removing
- Oil Pan Bolt
- Tightening sequence. Refer to Fig 2
- Replace after removing
Sheet Metal Oil Pan Lower Section - Tightening Sequence
NOTE:
Replace the bolts that were tightened with an additional turn.
-- Tighten the bolts -1 through 20- in two stages in the sequence shown:
| Step | Tightening Sequence and Tightening Specification |
|---|---|
| 1. Bolts -1 through 20- | 8 Nm |
| 2. Bolts -1 through 20- | 45° additional turn |
Oil Pan Upper Section - Tightening Sequence
NOTE:
Replace the bolts that were tightened with an additional turn.
-- Tighten the bolts -1 through 14- in the sequence shown:
| Step | Tightening Sequence and Tightening Specification |
|---|---|
| 1. Bolts -1 through 14- | 8 Nm |
| 2. Bolts -1 and 2- | 180° additional turn |
| 3. Bolts -3 through 9- | 45° additional turn |
| 4. Bolt -10- | 180° additional turn |
| 5. Bolts -11 through 14- | Turn an additional 90°. |