Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING

WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

The engine oil is drained. Refer to ENGINE OIL, DRAINING OR EXTRACTING; REPLACING OIL FILTER AND FILLING ENGINE OIL

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Disconnect the connector -3-.

Fig 1: Identifying Oil Level Thermal Sensor

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nuts -1- and the Oil Level Thermal Sensor -G266- -4-.

Installing

Fig 2: Identifying Oil Level Thermal Sensor

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install in reverse order of removal and note the following:

-- Replace the seal -2-.

-- Fill with engine oil and then check the level. Refer to ENGINE OIL, DRAINING OR EXTRACTING; REPLACING OIL FILTER AND FILLING ENGINE OIL

Tightening Specifications

Refer to OVERVIEW - OIL PAN/OIL PUMP