Sealing Flange with Sensor Wheel, Installing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Sealing flange -2- with PTFE-seal is equipped with a sealing lip support ring -3-. This support ring serves the same function of an assembly sleeve and must not be removed before installation.

Fig 1: Identifying Sealing Flange

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The sealing flange -2- and sensor wheel -3- must not be separated or rotated after being removed from the replacement part packaging.

The sensor wheel -3- retains the installation position via being located on the locating pin of the Seal Installer - Rear Crankshaft T10134, refer to Check The Installed Position Of The Sensor Wheel On The Crankshaft .

The sealing flange and seal are one unit and may only be replaced together with the sensor wheel.

The Seal Installer - Rear Crankshaft T10134 retains the installation position to the crankshaft via a guide pin, which is guided into the bore of the crankshaft, refer to Guide Pin For Diesel Engines (Black Handle) .

Installing the Seal Installer - Rear Crankshaft T10134.

Fig 2: Identifying Seal Installer - Rear Crankshaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A -

Tension surface

B -

Nut

C -

Assembly bell

D -