Check The Installed Position Of The Sensor Wheel On The Crankshaft

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Seal Installer - Rear Crankshaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the nut -B- up to the end of the threaded spindle.

-- Remove both bolts -2- from the cylinder block.

-- Remove guide pin for diesel engines (black handle) -G- from the crankshaft flange.

-- Remove the knurled bolts -H- from the sealing flange -1-.

-- Remove the hex socket head bolts -E- from the crankshaft flange and remove the Seal Installer - Rear Crankshaft T10134 from the crankshaft flange.

-- Remove the sealing lip support ring.

-- Attach the Depth Gauge VAS 6082 to the crankshaft flange -2-.

Fig 2: Identifying Depth Gauge

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Measure the distance -a- between the crankshaft flange -2- and the sensor wheel -1-.

Fig 3: Identifying Distance Between Crankshaft Flange And Sensor Wheel

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Specified value: Dimension -a- = 0.5 mm.

-- Install the sensor wheel again if the specified value is too small, refer to Sealing Flange with Sensor Wheel, Installing .

-- When the specified value is reached, assemble the rest, refer to Assembling .