Press on the Sensor Wheel

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Seal Installer - Rear Crankshaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure the Seal Installer - Rear Crankshaft T10134 on the crankshaft flange -2-.

-- Pay attention that the Seal Installer - Rear Crankshaft T10134 locating pin is seated in the sensor wheel hole.

-- Tighten the hex socket bolts -E- hand-tight.

-- Push the Seal Installer - Rear Crankshaft T10134 by hand to the sealing flange -1-.

-- Install the nut -B- as far as possible on the threaded spindle by hand until it touches the Seal Installer - Rear Crankshaft T10134.

-- Insert guide pin for diesel engines (black handle) -G- in the crankshaft flange.

-- Push the knurled bolts -H- in the sealing flange -1-.

-- Install two M6 x 35 bolts -2- into the cylinder block to guide the sealing flange.

-- Tighten the Seal Installer - Rear Crankshaft T10134 nut -B- to 40 Nm.

Fig 2: Identifying Seal Installer - Rear Crankshaft Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Check the sensor wheel installed position on the crankshaft one more time, refer to Check The Installed Position Of The Sensor Wheel On The Crankshaft .

-- Tighten the nut on the Seal Installer - Rear Crankshaft T10134 to 45 Nm if the specified value is too small.

-- Check the sensor wheel installed position on the crankshaft one more time, refer to Check The Installed Position Of The Sensor Wheel On The Crankshaft .