Overview - Sealing Flange, Belt Pulley Side

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Sealing Flange - Belt Pulley Side Overview

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Sealing Flange, Belt Pulley Side
- With crankshaft seal
- Replace after removing
- Removing and installing, refer to SEALING FLANGE, BELT PULLEY SIDE, REMOVING AND INSTALLING .
Bolt
- Tightening specification and sequence, refer to Fig 2.
Crankshafts - Toothed Belt Gear
- There must be no oil on the contact surface between the toothed belt sprocket and crankshaft
- Only possible to install in one position
Bolt
- Tightening specification, refer to -item 1- OVERVIEW - TOOTHED BELT => List Item:Bolt

Fig 2: Ribbed Belt Pulley Side Sealing Flange - Tightening Specifications and Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts in steps in the sequence shown:

Step	Bolts	Tightening Specification
1.	-1 through 10-	Install all the way in by hand.
2.	-1 to 6-	Diagonally in stages to 13 Nm
3.	-7 through 10-	13 Nm