Front Three-Point Seat Belt, Convertible: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Always read the General Safety Precautions before working on airbags, seat belt tensioners and battery cut-out units (pyrotechnic components. Refer to SAFETY PRECAUTIONS .
Refer to the special information regarding seat belt tensioners. Refer to BELT TENSIONER SAFETY PRECAUTIONS .

-- Disconnect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove side trim. Refer to SIDE TRIM PANEL, CONVERTIBLE .

-- Remove the sill panel strip. Refer to SILL PANEL STRIP .

-- Remove the bracket for the belt guide. Refer to REMOVING .

-- Guide the belt out of the belt guide bracket.

-- Remove the bolt -1- and the belt -2- and belt relay.

Fig 1: Identifying Bolt And Belt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

WARNING: Electrostatic charges may result in involuntary deployment of the belt tensioner. Therefore the technician must discharge static electricity from the body before separating the ignition and ground wiring. This is done, for example, by briefly grasping the chassis or door striker.

USA only

Fig 2: Identifying Connectors And Automatic Belt Retractor

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connectors -1- from the automatic belt retractor -2-.

Procedure for all vehicles

-- Disconnect the connector -2- from the automatic belt retractor -1-.

Fig 3: Identifying Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Fig 4: Identifying Screw, Automatic Belt Retractor And Tabs

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the screw -1-.

-- Remove the automatic belt retractor -2- and the tabs -3- from the B-pillar -arrow-.