Mounting Bracket: Installing

WARNING: This page is about a different car, the 2013 Volkswagen Beetle and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Some vehicles have a sound absorber -arrow- on the clutch pedal bracket.

Fig 1: Bracket With Sound Absorber

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Move the sound absorber back into its installed position.

Replace the self-locking nuts.

NOTE: Allocate all components.

-- Install the impact bolster support -2- and tighten the bolt -1- to specification, refer to Tightening Specifications .

Fig 2: Identifying Clutch Pedal Crash Bolster With Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the wire guide -1- under the steering column.

Fig 3: Identifying Cable Guide

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The tabs -arrow- on both sides must clip into the column.

-- Install the ground wire to the steering column and install the nut -arrow-.

Fig 4: Identifying Ground Wire And Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the left footwell vent, refer to "Vents" in [For engine(s) CVCA, CPRA, CBTA, CPKA, CPLA, CJAA, CBUA, CPPA, CCTA, CBFA] Removal and Installation .

-- Install the drivers side trim and the cover under the trim, refer to "Storage Compartments, Covers and Trim" in Removal and Installation .

-- Press the hose/line assembly or pipe -1- with a new seal or O-ring -2- into the clutch master cylinder connection -4- until the clip -3- fully engages.

Fig 5: Identifying Hose/Line Assembly, O-Ring, Master Cylinder Connection & Securing Clip

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull on the hose/line assembly to make sure it is secure.

-- After removing the Hose Clamps up to 25 mm Diameter 3094, bring the supply hose back to its original shape.

-- Bleed the clutch system, refer to CLUTCH SYSTEM, BLEEDING .

-- Install the battery and battery tray, refer to [For engine(s) CVCA, CPRA, CBTA, CPKA, CPLA, CJAA, CBUA, CPPA, CCTA, CBFA] Removal and Installation .

-- Install the air filter housing, refer to REMOVAL AND INSTALLATION .

-- Connect the battery and follow the procedure regarding what to do after connecting the battery, refer to [For engine(s) CVCA, CPRA, CBTA, CPKA, CPLA, CJAA, CBUA, CPPA, CCTA, CBFA] Removal and Installation .