Fuel Supply System Safety Precautions
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, and 2014 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
When working on the fuel supply, note the following:
WARNING:
There is a risk of injury because the fuel is under very high pressure.
- The fuel injection system is separated into a high-pressure section, a maximum of approximately 120 bar (1, 740 psi) and a low-pressure section of 4 to 7 bar (58 to 101 psi).
- Before opening high pressure area, fuel pressure must be reduced to a residual pressure of approximately 6 bar (87 psi). For the procedure, refer to HIGH FUEL PRESSURE, REDUCING .
To reduce the risk of personal injury and/or damage to the fuel injection and ignition system, always observe the following:
- The ignition must be switched off before connecting or disconnecting injection and ignition system wiring or tester cables.
- Wash the engine only when the ignition is turned off.
- If the connectors were disconnected and the engine was started, then malfunctions have been stored in the engine control module DTC memory: Generate Readiness Code in Guided Functions Vehicle Diagnosis Tester.
CAUTION:
Risk of damaging electronic components when disconnecting the battery.
- Complete the steps for disconnecting the battery.
- Disconnect the battery only when the ignition is turned off, refer to BATTERY, DISCONNECTING AND CONNECTING .
WARNING:
Burn risk due to escaping fuel.
- Because the Transfer Fuel Pump -G6- runs briefly when the battery is connected and the driver's door is opened, the voltage supply to the -G6- must be disconnected before opening the fuel system.
-- Remove the circlip for the Fuel Pump Control Module -SB- in the Fuse Panel B -J538- in the engine compartment E-box; fuse assignment, refer to appropriate Wiring Diagrams, Troubleshooting & Component Locations.