Heater And A/C Unit Overview (Climatronic)
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The removal and installation of the heater and A/C unit on vehicles with Climatronic is done according to the description. Refer to HEATER AND A/C UNIT .
- Defroster Door Motor -V107-
- With the Defroster Door Motor Position Sensor -G135-
- Removing and Installing. Refer to DEFROSTER DOOR MOTOR -V107- WITH DEFROSTER DOOR MOTOR POSITION SENSOR -G135- .
- Front Air Distribution Door Motor -V426-
- With the Front Air Distribution Door Motor Position Sensor -G642-
- Removing and Installing. Refer to FRONT AIR DISTRIBUTION DOOR MOTOR -V426- WITH FRONT AIR DISTRIBUTION DOOR MOTOR POSITION SENSOR -G642- .
- Left Footwell Vent Temperature Sensor -G261-
- Removing and Installing. Refer to LEFT FOOTWELL VENT TEMPERATURE SENSOR -G261- .
- Junction Box
- Right Footwell Vent Temperature Sensor -G262-
- Removing and Installing. Refer to RIGHT FOOTWELL VENT TEMPERATURE SENSOR -G262- .
- Right Temperature Door Motor -V159-
- With Right Temperature Door Potentiometer/Actuator -G221-
- Removing and Installing. Refer to RIGHT TEMPERATURE DOOR MOTOR -V159- AND RIGHT TEMPERATURE DOOR POTENTIOMETER/ACTUATOR -G221 - .
- Hose for Glove Compartment Cooling
- Removing and Installing. Refer to GLOVE COMPARTMENT COOLING .
- Valve for the Glove Compartment Cooling
- Removing and Installing. Refer to GLOVE COMPARTMENT COOLING .
- Fresh Air/Recirculating Air/Back Pressure Door Motor -V425-
- With Fresh Air/Recirculating Air/Back Pressure Door Motor Position Sensor -G644-
- Removing and Installing. Refer to FRESH AIR/RECIRCULATING AIR/BACK PRESSURE DOOR MOTOR -V425- WITH FRESH AIR/RECIRCULATING AIR/BACK PRESSURE DOOR MOTOR POSITION SENSOR -G644- .
- Seal
- Air Intake Housing
- Fresh Air-, Air Recirculation-, Back Pressure Door
- Condensation Water Drain
- Removing and installing, checking CONDENSATION WATER DRAIN
- Bracket
- Evaporator Housing Upper Section
- Evaporator housing assembly overview. Refer to EVAPORATOR HOUSING OVERVIEW .
- Wiring Harness for Heater and Air Conditioner
- Evaporator Housing Lower Section
- Evaporator housing assembly overview. Refer to EVAPORATOR HOUSING OVERVIEW .
- Fresh Air Blower -V2-
- With Fresh Air Blower Control Module -J126-
- Fresh Air Blower -V2-, removing and installing. Refer to FRESH AIR BLOWER -V2- .
- Fresh Air Blower Control Module -J126-, removing and installing. Refer to FRESH AIR BLOWER CONTROL MODULE -J126- .
- Front Passenger Side Footwell Trim Panel
- Dust and Pollen Filter Cover
- Dust and Pollen Filter
- With activated charcoal insert
- Dust and pollen filter general information. Refer to DUST AND POLLEN FILTER .
- Removing and Installing. Refer to DUST AND POLLEN FILTER .
- Evaporator Temperature Sensor -G308-
- Removing and Installing. Refer to EVAPORATOR TEMPERATURE SENSOR -G308- .
- Heater Core
- Removing and installing. Refer to HEATER CORE .
- After replacing heater core, replace all the coolant. Refer to GENERAL INFORMATIONGENERAL INFORMATIONGENERAL INFORMATIONGENERAL INFORMATIONGENERAL INFORMATION .
- Auxiliary Heater Heating Element -Z35-
- Only installed on vehicles with Diesel engine without auxiliary water heater
- Removing and installing. Refer to AUXILIARY HEATER HEATING ELEMENT -Z35- .
- Switch-on criteria. Refer to SWITCH-ON CRITERIA FOR THE ACTIVATION OF THE AUXILIARY HEATER HEATING ELEMENT -Z35-
- Switch-off criteria. Refer to SWITCH-OFF CRITERIA FOR THE ACTIVATION OF THE AUXILIARY HEATER HEATING ELEMENT -Z35-
- Evaporator
- Removing and Installing. Refer to EVAPORATOR .
- Expansion Valve
- Removing and Installing. Refer to EXPANSION VALVE .
- Seal
- Left Temperature Door Motor -V158-
- With Left Temperature Door Potentiometer/Actuator -G220-
- Removing and Installing. Refer to LEFT TEMPERATURE DOOR MOTOR -V158- AND LEFT TEMPERATURE DOOR POTENTIOMETER/ACTUATOR -G220 - .