Evaporator Housing Overview
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Bolts
- Tightening specification 1.5 Nm
- Evaporator Housing Upper Section
- Bolts
- Quantity: 2
- Tightening specification 5 Nm
- Threaded Plate
- To attach the refrigerant lines to the evaporator
- Expansion Valve
- Removing and Installing. Refer to EXPANSION VALVE .
- Seal/Insulation
- Heat insulation for expansion valve
- Evaporator Housing Lower Section
- Evaporator
- Check insulation, it must be completely present
- Removing and Installing. Refer to EVAPORATOR .