Selector Shaft Seal, Replacing: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Coat the outer circumference and the sealing lip on the oil seal with ATF.

Installed position: open side of the seal toward the transmission housing.

-- Install the new seal all the way using Seal Installer - Selector Shaft Oil Seal T10174. Do not tilt the seal when doing this.

Fig 1: Identifying New Gasket Driven In Until Stop Using Thrust Piece T10174

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the Multifunction Transmission Range Switch -F125-. Refer to Installing .

-- Adjust the Multifunction Transmission Range Switch -F125-. Refer to Adjusting .