Multifunction Transmission Range Switch -F125-, ADJUSTING: Adjusting

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the Gauge - Multi Function Switch T10173 on the selector shaft -2- and turn the Multifunction Transmission Range Switch -F125- -1- until the Gauge - Multi Function Switch T10173 locks into the tab on the Multifunction Transmission Range Switch -F125- connector.

Fig 1: Adjustment Tool Attached Onto Shift Rod

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE: If the tab on the connector does not engage in the Gauge - Multi Function Switch T10173 groove, then the transmission is no longer in "N". In this case, shift the transmission into "N" using the Gauge - Multi Function Switch T10173.

-- Secure the Gauge - Multi Function Switch T10173 to the selector shaft -2- with the screw -3-.

-- Tighten the bolts -arrows- to the tightening specification.

-- Remove the Gauge - Multi Function Switch T10173.

-- Further installation is performed in the reverse sequence. Refer to Multifunction Transmission Range Switch -F125- .