Input Shaft Seal, Replacing

WARNING: This page is about a different car, the 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Needle Bearing DriftVW295
AdapterVW295 A
Thrust TubeVW454
Press Tube2040

Transmission is removed.

-- Remove the clutch release lever with the release bearing and guide sleeve, refer to CLUTCH RELEASE MECHANISM, SERVICING .

-- Drive seal out of guide sleeve.

Fig 1: Drive Seal Out Of Guide Sleeve

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Be careful not to damage the contact surface for the seal on the input shaft.

-- Fill the area between the sealing lip and dust lip -arrow- halfway with Sealing GreaseG 052 128 A1.

Fig 2: Identifying Oil Seal

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Coat the outer circumference of the seal lightly with transmission fluid.

-- Install the seal all the way into the guide sleeve.

Fig 3: Drive Oil Seal Into Guide Sleeve Onto Stop Using Special Tools VW295, VW295A & VW454

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the clutch release lever with the release bearing and guide sleeve, refer to CLUTCH RELEASE MECHANISM, SERVICING .

Tightening Specifications

Guide sleeve to the clutch housing, refer to CLUTCH RELEASE MECHANISM OVERVIEW .