Abs Mark 60 Ed, Abs, Eds, ASR And Esp, Vehicles With Electro-Magnetic Power Steering
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Components Location Overview - ABS Mark 60 ED, ABS, EDS, ASR And ESP, Vehicles With Electro-Magnetic Power Steering
- Anti-lock Brake System (ABS) Control Module -J104-
- Component location: on the ABS Hydraulic Unit -N55- inside the engine compartment on the right side.
- Do not disconnect connector before successfully completing On Board Diagnostic (OBD). Turn off the ignition before disconnecting the connector.
The following components are integrated inside the Anti-lock Brake System (ABS) Control Module -J104- :
- Transverse Acceleration Sensor -G200-
- Rotation Rate Sensor -G202-
- Longitudinal Acceleration Sensor -G251- (depending on vehicle equipment)
- Removing and installing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55- .
- Disconnecting from the ABS Hydraulic Unit -N55-. Refer to ABS Control Module -J104-, DISCONNECTING FROM ABS Hydraulic Unit -N55-, ABS MARK 60 EC .
- ABS Hydraulic Unit -N55-
- Installed location: inside the engine compartment on the right side
The ABS Hydraulic Unit -N55- consists of the following components:
- Anti-lock Brake System (ABS) Hydraulic Pump -V64-
- Brake Pressure Sensor 1 -G201-
- Valve block (contains inlet and outlet valves)
- The Anti-lock Brake System (ABS) Hydraulic Pump -V64- and valve block must not be separated from one another.
- Removing and installing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55- .
- Disconnecting from the Anti-lock Brake System (ABS) Control Module -J104-. Refer to ABS Control Module -J104-, DISCONNECTING FROM ABS Hydraulic Unit -N55-, ABS MARK 60 EC .
- Installed location: inside the engine compartment on the right side
- ASR/ESP Indicator Lamp 2 -K216-
- Component location: inside the instrument cluster
- Malfunctions displayed by warning lamps. Refer to ABS MARK 60 ED, ABS, EDS, ASR AND ESP, VEHICLES WITH ELECTRO-MAGNETIC POWER STEERING, USA AND CANADA .
- ASR/ESP Indicator Lamp -K155-
- Only on vehicles with Anti-lock Brake System (ABS)/EDL/ASR/ESP
- Component location: inside the instrument cluster
- Malfunctions displayed by warning lamps. Refer to ABS MARK 60 ED, ABS, EDS, ASR AND ESP, VEHICLES WITH ELECTRO-MAGNETIC POWER STEERING, USA AND CANADA .
- Anti-lock Brake System (ABS) Indicator Lamp -K47-
- Component location: inside the instrument cluster
- Malfunctions displayed by warning lamps. Refer to ABS MARK 60 ED, ABS, EDS, ASR AND ESP, VEHICLES WITH ELECTRO-MAGNETIC POWER STEERING, USA AND CANADA .
- Brake Pad Wear Indicator Lamp -K32-
- Component location: inside the instrument cluster
- Malfunctions displayed by warning lamps. Refer to ABS MARK 60 ED, ABS, EDS, ASR AND ESP, VEHICLES WITH ELECTRO-MAGNETIC POWER STEERING, USA AND CANADA .
- Brake System Indicator Lamp -K118-
- Component location: inside the instrument cluster
- Malfunctions displayed by warning lamps. Refer to ABS MARK 60 ED, ABS, EDS, ASR AND ESP, VEHICLES WITH ELECTRO-MAGNETIC POWER STEERING, USA AND CANADA .
- Diagnostic Connection
- Component location: driver side footwell cover
- Steering Gear
- with Steering Angle Sensor -G85-
- Use the Vehicle Diagnostic Tester for the Steering Angle Sensor -G85- fault diagnostics
- For the correct allocation. Refer to Vehicle Diagnostic Tester
- Removing and Installing. Refer to REMOVAL AND INSTALLATION .
- Rear Speed Sensor --
- Removing and installing. Refer to RIGHT/LEFT REAR ABS WHEEL SPEED SENSOR -G44- / -G46- .
- Rear Wheel Bearing Unit
- The Anti-lock Brake System (ABS) sensor ring is installed in the wheel bearing
- Front Wheel Bearing Unit
- The Anti-lock Brake System (ABS) sensor ring is installed in the wheel bearing
- Front Speed Sensor --
- Removing and installing. Refer to RIGHT/LEFT FRONT ABS WHEEL SPEED SENSOR -G45- / -G47- .
- Brake Lamp Switch -F-
- Including the Brake Pedal Switch -F47-
- Installed location: on the master brake cylinder
- Removing and installing. Refer to BRAKE LAMP SWITCH .