Abs Mark 60 Ed, Abs, Eds, ASR And Esp, Vehicles With Electro-Magnetic Power Steering, USA And CANADA
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Components Location Overview - ABS Mark 60 ED, ABS, EDS, ASR And ESP, Vehicles With Electro-Magnetic Power Steering, USA And Canada
- Anti-lock Brake System (ABS) Control Module -J104-
- Component location: on the ABS Hydraulic Unit -N55- inside the engine compartment on the right side.
- Do not disconnect connector before successfully completing On Board Diagnostic (OBD). Turn off the ignition before disconnecting the connector.
The following components are integrated inside the Anti-lock Brake System (ABS) Control Module -J104- :
- Transverse Acceleration Sensor -G200-
- Rotation Rate Sensor -G202-
- Longitudinal Acceleration Sensor -G251- (depending on vehicle equipment)
- Removing and installing. Refer to ABS Control Module -J104- AND ABS Hydraulic Unit -N55- WITH 4-CYLINDER GASOLINE ENGINE AND ABS MARK 60 EC ABS/EDL/ASR/ESP .
- ABS Hydraulic Unit -N55-
- Installed location: inside the engine compartment on the right side
The ABS Hydraulic Unit -N55- consists of the following components:
- Anti-lock Brake System (ABS) Hydraulic Pump -V64-
- Brake Pressure Sensor 1 -G201-
- Valve block (contains inlet and outlet valves)
- The Anti-lock Brake System (ABS) Hydraulic Pump -V64- and valve block must not be separated from one another.
- Removing and installing. Refer to ABS Control Module -J104- AND ABS Hydraulic Unit -N55- WITH 4-CYLINDER GASOLINE ENGINE AND ABS MARK 60 EC ABS/EDL/ASR/ESP .
- Installed location: inside the engine compartment on the right side
- Indicator Lamp for ESC Off --
- Component location: inside the instrument cluster
- ESC Indicator lamp --
- Component location: inside the instrument cluster
- Anti-lock Brake System (ABS) Indicator Lamp -K47-
- Component location: inside the instrument cluster
- Brake Pad Wear Indicator Lamp -K32-
- Component location: inside the instrument cluster
- Brake System Indicator Lamp -K118-
- Component location: inside the instrument cluster
- Diagnostic Connection
- Component location: driver side footwell cover
- Steering Gear
- with Steering Angle Sensor -G85-
- Removing and Installing. Refer to REMOVAL AND INSTALLATION .
- Use the Vehicle Diagnostic Tester for the Steering Angle Sensor -G85- fault diagnostics
- For the correct allocation. Refer to Vehicle Diagnostic Tester
- Rear Speed Sensor --
- Removing and installing. Refer to RIGHT/LEFT REAR ABS WHEEL SPEED SENSOR -G44- / -G46- .
- Rear Wheel Bearing Unit
- The Anti-lock Brake System (ABS) sensor ring is installed in the wheel bearing
- Front Wheel Bearing Unit
- The Anti-lock Brake System (ABS) sensor ring is installed in the wheel bearing
- Front Speed Sensor --
- Removing and installing. Refer to RIGHT/LEFT FRONT ABS WHEEL SPEED SENSOR -G45- / -G47- .
- Brake Lamp Switch -F-
- Including the Brake Pedal Switch -F47-
- Installed location: on the master brake cylinder
- Removing and installing. Refer to BRAKE LAMP SWITCH .