Assembly Mounts Overview

WARNING: This page is about a different car, the 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Assembly Overview: Engine And Transmission Mount

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Bolt
- Transmission support to transmission
  Tightening Specifications:
- Vehicles with a manual transmission, refer to SPECIFICATIONS .
- Vehicles with a DSG transmission, refer to FASTENER TIGHTENING SPECIFICATIONS .
Bolts
- Pendulum supports to transmission
- Replace after removing
- 50 Nm +90°
Engine Support
Bolt
- Engine support to engine
- Replace after removing
- 40 Nm +180°
Engine Mount
- Removing and Installing. Refer to ENGINE MOUNT .
Bolt
- Engine mount to body
- Replace after removing
- 40 Nm +90° (¹ /₄ turn) additional turn
Bracket
Bolt
- Bracket to engine mount
- Replace after removing
- 20 Nm +90° (¹ /₄ turn) additional turn
Bolt
- Bracket to body
- Replace after removing
- 20 Nm +90° (¹ /₄ turn) additional turn
Bolt
- Engine mount to body
- Replace after removing
- 40 Nm +90° (¹ /₄ turn) additional turn
Bolts
- Engine mount to engine support
- Replace after removing
- 60 Nm +90° (¹ /₄ turn) additional turn
Pendulum Support
- First install pendulum support to the transmission and then to the subframe
Bolt
- Pendulum supports to subframe
- Replace after removing
- 100 Nm +90° (¹ /₄ turn) additional turn
Bolt
- Transmission mount to transmission support
- Replace after removing
- 60 Nm +90° (¹ /₄ turn) additional turn
Bolt
- Transmission mount to body
- Replace after removing
- 40 Nm +90° (¹ /₄ turn) additional turn
Transmission Mount
- The illustration shows the DSG transmission version
Bolt
- Transmission support to transmission
  Tightening Specifications:
- Vehicles with a manual transmission, refer to SPECIFICATIONS .
- Vehicles with a DSG transmission, refer to FASTENER TIGHTENING SPECIFICATIONS .
Gearbox Support