Transmission Fluid Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the transmission fluid pump input shaft -A- all the way into the transmission. Turn the input shaft while doing this.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Always use a new metal seal -B-.

The two alignment pins -C- must be inside the transmission housing.

NOTE:

When positioning the transmission fluid pump, pay attention to the drive axle splines -A- and the correct seating on the alignment pins -C-.

-- Place the transmission fluid pump on the input shaft and tighten. Refer to Tightening Specification and Sequence for Transmission Fluid Pump .

-- Install the transmission fluid pump cover. Refer to TRANSMISSION FLUID PUMP COVER, REMOVING AND INSTALLING .