Left Seal, Replacing: Installing
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
-- Lightly oil the new gasket on the outer edge.
-- Fill the area between the sealing lip and dust lip -Arrow- halfway with Sealing Grease.
-- Install the seal all the way in without tilting it.
-- Install the flange shaft.
-- Hold the flange shaft to the transmission and tighten.
-- Install the left drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
-- Check the transmission fluid level. Refer to TRANSMISSION FLUID LEVEL, CHECKING .
-- Install the lower section of the left front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .
-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Install the wheel. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .