Clutch Pedal, Removing And Installing: Installing
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-1- = 14 mm internal socket wrench
A 14 mm hex socket wrench can also be used instead of a 14 mm internal socket wrench.
- Replace bearing axle after removing.
-- Press on the clutch pedal a little and push the new bearing axle through all the way.
-- Turn the bearing axle all the way to the right, direction of -arrow-.
- The retainers -A- must engage audibly.
-- Install return spring in mounting bracket. Refer to RETURN SPRING, REMOVING AND INSTALLING , or over-center spring in mounting bracket. Refer to OVER-CENTER SPRING, REMOVING AND INSTALLING .
-- If removed, install the bracket -arrow- with Parking Aid Control Module -J446-. Refer to PARKING AID .