LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Transmission System (Gears & Shafts - Service Information - 6-Speed Manual - 02Q)) >> 35 Gears, Shafts >> Output Shaft >> Output Shaft, Disassembling And Assembling >> Output Shaft, 5TH, 6TH And Reverse Gears, Disassembling And Assembling >> Removing the Inner Race/Tapered Roller Bearing on the Side of the Clutch Housing.

Removing the Inner Race/Tapered Roller Bearing on the Side of the Clutch Housing.

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
GWWN35-0260Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mount the :30-11  on the output shaft before removing the puller.

Assemble the Output Shaft.

NOTE:

Heat the inner races of the tapered roller bearing and synchronizer hub to approximately 100 °C (212 °F) with the :VAS6414  before installing. Press on as far as the stop so there is no axial play.

scientia non olet · About LEMON Manuals