Output Shaft, 5TH, 6TH And Reverse Gears, Disassembling And Assembling: Notes
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Press Plate:VW401
- Press Plate:VW402
- Press Piece - Rod:VW407
- Press Piece - Rod:VW408A
- Press Piece - Multiple Use:VW412
- Press Piece - 60mm:VW415A
- Holding Plate:VW309A
- Transmission Support:VW353
- Press Piece - Multiple Use:VW433
- Press Piece - Multiple Use:VW454
- Support Channels:VW457
- Crankshaft Holding Fixture:VW801
- Press Piece - Multiple Use:VW431
- Press Piece - Multiple Use:VW455
- Press Piece - Multiple Use:VW510
- Press Piece - 42mm:VW516
- Press Piece - Multiple Use:VW519
- Press Piece - Multiple Use:30-11
- Press Piece - Multiple Use:40-105
- Bearing Installer - Multiple Use:40-20
- Slide Hammer - Press Plate:2050
- Press Piece - Reverse Gear Syncro:3296
- Puller - Taper Roller Bearing:VAG1582
- Puller - Taper Roller Bearing - Adapter 4:VAG1582/4
- Puller - Taper Roller Bearing - Adapter 7:VAG1582/7
- Inductive Heater:VAS6414
- -1- Internal Puller:VAS251615 (21-7)
- -3- Splitter:VAS251411 (17-2)
- -4- Counter Support:VAS251623 (22-2)