LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Transmission System (Gears & Shafts - Service Information - 6-Speed Manual - 02Q)) >> 35 Gears, Shafts >> Output Shaft >> Output Shaft, Disassembling And Assembling >> Output Shaft, 5TH, 6TH And Reverse Gears, Disassembling And Assembling >> Installing the Locking Collar/Synchronizer Hub for 5th and 6th Gears

Installing the Locking Collar/Synchronizer Hub for 5th and 6th Gears

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
GWWN35-0265Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

On some locking collars, there is a chamfer on the outer diameter.

Installation position: the bevel on the outer diameter of the locking collar faces toward the 5th gear wheel.

-- Turn the synchronizer ring so that the grooves line up with the locking pieces.

-- Install the circlip.

-- Install the 5th gear synchronizer ring.

-- Install 5th gear wheel with needle bearing.

scientia non olet · About LEMON Manuals